How to prevent the circuit harness of walkie stacker from failure?

The walkie stacker is a storage and logistics vehicle that is controlled by electric power to move and lift. Therefore, there are many circuit harnesses inside it. If there is a problem with the circuit harness, the normal operation of the whole forklift will be affected. Moreover, the circuit harnesses of the electric forklift are many and complex, and it takes a lot of time after the problem occurs, which affects the work efficiency. If you want to avoid these problems and prevent them before they occur, you should check regularly and do a good job of prevention. So, how do we check whether there is a potential safety hazard in the circuit harness, and how to prevent it? The pallet stacker manufacturer will tell you about it.

We should pay attention to the problems exposed in the circuit when checking whether there are potential safety hazards in the circuit of the walkie stacker. For example, there is wear at the corner of the circuit harness, and there is a short circuit between the wire and the adhesive edge of the wire. This kind of grounding caused by damage is easy to be ignored and often becomes a difficult fault. There are also some common problems, such as the harness near the engine, exhaust pipe, water pipe and other heat sources, which may be burnt or even scorched due to the lack of fixing of the harness clip. For a long time, this problem is likely to cause the electrical equipment to not work properly. Another example is that some wires are connected irregularly due to human reasons, which will cause the fuse to be burnt over time. The pallet stacker manufacturer tells us that these problems should be paid attention to when we check the circuit harness of walkie stacker.

So, how can we prevent the circuit harness of walkie stacker from failure? First of all, when we connect the circuit harness, we must not connect it randomly, which leads to the confusion of the harness, more than the wires and more exposed wire ends. Once a problem occurs, it will be difficult to find the cause of the failure. In serious cases, it will also cause fire and cause accidents. Secondly, during maintenance, it is necessary to comply with the repair specifications, and the wiring shall be arranged according to the standard line color, code and number of the low-voltage line of the walkie stacker. It is not allowed to connect the power line when the fault has not been eliminated. The pallet stacker manufacturer reminded that if a certain section of circuit harness is damaged, it is absolutely not allowed to change the wire at will. Before replacing the fuse, turn off all electrical equipment and replace it according to regulations.

This is the method to check the circuit harness of the walkie stacker and the suggestions on how to prevent the failure of the circuit harness. The problems of the circuit harness of the electric forklift are mostly hidden, mostly caused by wires, which is difficult to troubleshoot. Therefore, the pallet stacker manufacturer reminds us that we should comply with the operating specifications when wiring and maintaining, and often maintain the circuit harness to avoid potential safety hazards as much as possible.